Philips PFL38X7H Channel settings, More sound settings, Select audio format, Automatic install

More sound settings

You can change the settings in the Sound menu.

1.Press .

2.Select [Setup] > [TV settings] > [Sound],

then press OK.

3.Select a setting to change, then press OK: ∙ [Smart sound]: Access predefined

smart sound settings.

∙ [Reset]: Reset to factory default

settings.

∙ [Clear Sound]: Enhance the sound

quality.

∙ [Bass]: Change the bass level.

∙ [Treble]: Change the treble level.

∙ [Surround]: Switch on spatial sound.

∙ [Auto volume levelling]: Automatically reduce sudden volume changes, for

example when switching channels.

∙ [Headphone volume]: Change

headphone volume.

∙ [Balance]: Change the balance of the

left and right speakers.

∙ [Audio out delay]: Automatically sync the image on the TV to the audio from

a connected home theatre.

∙ [Audio out offset]: Change the setting

for audio output delay. You cannot select this setting if [Audio out delay] is

not switched on.

∙[Digital output format]: Select audio

output through the digital audio connector. Select [PCM] to convert non-PCM audio or [Multichannel] to output to home theatre.

∙[Digital output level]: Set the sampling

rate for PCM audio.

[Normal] - No loss in intensity or signal strength; [Low] - Certain amount of loss in intensity or signal strength.

EN 26

Select audio format

If a digital TV channel broadcaster streams audio in several formats, you can select an audio format.

1.Press .

2.Select [Setup] > [Channel settings] or

[Satellite settings] > [Language].

3. Select a setting, then press OK:

∙[Preferred audio format]: Receive standard audio format (MPEG) or advanced audio formats (AAC, EAC-3 or AC-3 if available).

∙[Mono/Stereo]: If stereo broadcasting is available, select mono or stereo audio.

4. Press to exit.

Reset picture and sound

You can restore the default picture and sound settings, while the channel installation settings remain the same.

1.While you watch TV, press .

2.Select [Setup] > [TV settings] > [Factory

settings], then press OK.

All TV settings (except for channel settings) are reset to the default factory settings..

Channel settings

Automatic install

When the TV was switched on for the first time, a full installation of channels was performed. To change your language, country and reinstall all available TV channels, you can run this full installation again.

Start installation

1.Press .

2.Select [Setup] > [Search for channels] >

[Reinstall channels], then press OK. The Country menu is displayed.

3.Select your country, then press OK.

4.Select your network, then press OK:

∙[Antenna]: Access free-to-air antenna or digital DVB-T channels.

∙[Cable]: Access cable or digital DVB-C channels.