User Manual BDH5011
5 1
9 6
RS-232
7.6RS-232 Remote Control Connections
RS-232 Serial Terminal Overview
This display is equipped with an
Communications Parameters
These parameters are required to setup communications with the display.
Specification: | |
Sync Method: | Synchronous |
Baud Rate: | 9600 bps |
Parity: | None |
Character: | Length 8 Bits |
Stop Bit: | 1 Bits |
Pin Layout for RS-232 Terminal
The
Carrier Detect)
Pin 2: Received Data (RXD)
Pin 3: Transmit Data (TXD)
Pin 4: Data Terminal Ready (DTR)
Pin 5: Signal Ground
Pin 6: Data Set Ready (DSR)
Pin 7: Request To Send (RTS)
Pin 8: Clear To Send (CTS)
Pin 9: Ring Indicator
Basic Format for Command Parameters In order to transmit data from the computer to the display, the data must be sent in
The command code (see table below) must first be sent to the display, followed by the desired value setting in hexadecimal format.
The following is an example of a sequence to change the displays input to RGB:
Step 1: Send
Step 2: Send
Step 3: The display will then respond back to the PC with a
20