Install channels, Other options | Philips 42PFL76X5C, 42PFL76X5H

Other options

Select audio language

If the TV channel has multiple or dual sound broadcast, you can select the preferred audio language.

1. While watching TV, press .

∙[Audio language]: Select the audio language for digital channels.

∙[Dual I-II]: Select the audio language for analog channels.

Select video stream (for DVBS channel only)

If available, you can view different video stream of the channel. (depending on broadcast service provider)

1.While watching TV, press .

2.Select [Video selection] to view the

various selection.

Install channels

Automatic install

When the TV was switched on for the first time, a full installation of channels was performed. You can redo this full installation again to set your language, country and install all available TV channels.

Note: If you are prompted to enter a code, enter '8888'.

1.Press .

2.Select [Setup] > [Search for channels],

then press OK.

3.Follow the on-screen instructions to complete the channel installation.

4.Once complete, select [Finish], then press OK.

Tip: Press to see the channel list.

Notes

∙During installation, leave [Settings] unchanged unless your digital provider provides you with the specific values to enter.

EN 36

∙When digital TV channels are found, the list of installed channels may display empty channel numbers. You can rename, reorder or uninstall these channels.

Access DVB-C or DVB-T channels

If you have installed both DVB-C and DVB-T channels, you have to switch to the respective network to watch channels on that network.

1.While watching TV, press .

2.Select [Setup] > [Channel settings].

3.Select [Channel installation] > [Antenna or Cable DVB].

4.Select one of the following settings:

∙[Antenna (DVB-T)]: Access free-to-air antenna or digital DVB-T channels

∙[Cable]: Access cable or digital DVB-C channels.

3.Press OK to confirm your choice.

4.Press to exit.

The TV switches to the selected channel list.

Install analog channels

NonPublish

This section describes how to search and

store analog TV channels manually. Step 1: Select your system

Note: Skip this step if your system settings are correct.

If you are prompted to enter a code, enter '8888'.

1.While watching TV, press .

2.Select [Setup] > [Channel settings] >

[Channel installation] > [Analogue: Manual installation] > [System], then press OK.

3.Select the system for your country or region, then press OK.

Step 2: Search and store new TV channels

1.In the [Analogue: Manual installation] menu, select [Find channel], then press OK.

2.Press:

∙The Navigation buttons or Numeric buttons to manually enter the channel frequency.