Remote Control keys (DVD or AUX)
The remote control also allows you to control the main functions of some Philips DVD models
NOTE : Functions not available to Philips
Press the 
key to select the required mode: DVD or AUX.
The remote control indicator lights up to display the selected mode. It switches off automatically after 20 seconds if left idle. The mode automatically returns to TV mode.
The following buttons are operational, depending on the equipment:
standby |
| pause |
fast rewind |
| display and exit menu |
stop |
| programme selection |
|
| |
play |
|
|
|
| navigation and adjustments, |
fast forward |
| confirms selection |
record | to | digit keys |
Quick Installation
When you switch on the TV set for the first time, a menu is displayed on screen. This menu prompts you to select the country and language for the menus.
Plug’n’Play
CountryLanguage
GB 
English
Note
If the above menu is not displayed, proceed to do the installation of channels by the
Auto Store method (see page 7). If above menu is displayed, proceed to do the following steps.
&Use the Î ï keys on the remote control
to select your country. If your country does
not appear in the list, select “. . . “ . Refer to the “Reference table of Countries available for selection” on page 19
éUse the Æ key to move to the Language mode and select your language by the Î ï keys.
“ Use the Æ key to start search.
The search starts automatically. All the available TV programmes will be stored. This operation takes a few minutes. The display shows the progress of the search and the number of programmes found.
Important : To exit or interrupt the search
before it is completed, press the 
key. If you interrupt search during auto store, not all channels will be stored. For all channels to be stored, you need to do a complete auto store search again.
Note
ATS (Automatic Tuning System) feature If the transmitter or cable network sends the automatic sort signal, the programmes will be numbered correctly. In this case, the installation is complete. If this is not the case, you need to use the Sort menu to number the programmes correctly.
ACI (Automatic Channel Installation) feature
If a cable system or a TV channel which broadcasts ACI is detected, a programme
list appears. Without ACI broadcast, the channels are numbered according to your language and country selection. You can
use the Sort menu to renumber them.
Some transmitters or cable networks broadcast their own sort parameters (region, language, etc.). In this case, indicate your choice using the Î ï keys and confirm with Æ key.
6