Searching for tape position without picture (forward wind and rewind)
1.Stop the tape with STOP
2.Press REW0- s (reverse) or FWD 1- B
(forward).
3.To stop the tape, press STOP
Manual Tracking
To manually adjust the tracking during playback, press PROGRAMME+
PROGRAMME- or PROG P+
PROG
Tracking will return to Automatic Tracking Adjustment when you press STOP
To remove vertical jitter in a Still picture, press PROGRAMME+
PROGRAMME- or PROG P+ 
PROG
6. Manual recording
General information
Use 'Manual Recording' to make a spontaneous recording (for example, a programme currently being shown).
If you want to start and stop a recording manually, read the section 'Recording without automatic
If you want to start a recording manually but have it stopped automatically, read the section 'Recording with automatic
to record to the end of the tape)
Recording without automatic switch-off
1.Insert a cassette.
2.Use PROG P+ 
PROG P– to select the pro- gramme number you want to record, for
example, 'P01'.
3.To start recording, press REC I .
4.Stop recording with STOP
Preventing accidental erasing
All cassettes (except rental and
To prevent recording over important recordings (erasing), you can remove this security tab.
If you later decide to record on a protected cas- sette, simply cover the hole with adhesive tape or slide the tab to the right.
Lining up recordings (assemble cut)
When you add a further recording to a cassette, which already has a recording on it, a short blank (flicker) can appear between the old and the new recording or the picture itself can flicker. To help reduce these from occurring, proceed as follows:
1.Find the tape position of the old recording where you want to insert the new recording.
2.Look at the last minute of the old recording (playback).
3.Press STILL 2 at the tape position where the new recording is to go and press REC I .
4.Now start recording as usual by pressing REC I on the remote control.
5.Stop recording with STOP
10 | EN |
|