Record to Hard Disk (continued)
English
About timer recording
Use the timer recording to automatically start and stop a recording at a later date/ time. This recorder will tune to the right programme channel and begin recording at the specified time.
With this recorder, you can schedule up to 25 recordings at a time and up to 6 (six) hours for each recording. During timer recording, changing the recorder’s channel is not possible.
There are three ways to programme a timer recording
–Using the GUIDE Plus+ system
–Using the ShowView / VIDEO Plus+ system
–Manual timer recording
About ‘VPS/PDC’
‘VPS’ (Video Programming System) or ‘PDC’ (Programme Delivery Control) is used to control the start and duration of TV channel recordings. If a TV programme starts earlier or ends later than was scheduled, this recorder will then turn on and off at the correct time.
Timer recording (GUIDE Plus+ system)
To schedule a recording with the GUIDE Plus+ system, simply select the desired programme from the channel list.
A Turn on the TV to the correct programme number for the recorder (e.g. ‘EXT’, ‘0’, ‘AV’).
B Turn on the recorder and press GUIDE on the remote control.
The GUIDE Plus+ screen appears.
Note: If the GUIDE Plus+ setup menu appears, it means that this recorder has not been installed with the GUIDE Plus+ programme data yet. See pages 28~29 to
C Use | keys to select a desired TV | |
channel and use | keys to select a | |
programme. |
| |
Press CH +/- to scroll down/up a page at a time.
Press 
to go directly to a day before or the next day TV listings.
D Press the Red button on the remote
control for 
.
E Press GUIDE to exit the menu.
TIPS: Set the appropriate recording mode. It determines the actual recordable time to the HDD or a recordable DVD, see page 38.
42
dvdr9000h_eu_eng2.indd 42