T6460/550/552EZ(EN)_EST.qx3 04.1.28 4:15 PM Page 15
9. Before you call an engineer
If, contrary to expectation, you have any prob- lems using this
Your
•There is no power supply: check the power supply.
•Parental control is on: switch the parental con- trol off.
•A programmed recording is currently being made: if desired, cancel the programmed recording. Please see the section ‘Problems and solutions for programmed recordings’ in chapter ‘Programming a recording (TIMER)’.
•There is a technical problem: disconnect from
the mains power supply for 5 minutes, then
Resetting devices to default factory settings
*Attention: all the information stored (time and date, TIMER) will be cleared.
1.Switch the
2.Press and hold REC I and PROG P+ at the same time for 2 seconds or more.
Cassette is jammed in the
•Don’t use force. Pull out the mains plug for the moment. Then, call an engineer.
Remote control does not work:
•Remote control not pointed toward the TV- Video Combi: point it at the
•There is a technical problem: take out the bat- teries, wait for 10 seconds and place them back.
•Batteries have run out: change the batteries.
No picture when you play a cassette:
•There is no recording on the cassette: change the cassette.
Poor picture quality when you play a cas- sette:
•Your TV is not properly adjusted.
•The cassette is badly worn or of poor quality: use new cassette.
•Tracking is not properly adjusted: turn to sec- tion ‘Manual tracking’.
•Magnetism from nearby appliances and geo- magnetism might affect the colour of the TV picture. Move the
No recording possible:
•The TV channel you want to record is not stored or you selected the wrong programme number: check TV channels stored.
•A cassette was inserted that does not have the security tab (cannot be used to record): cover the hole with adhesive tape or use a cassette with an intact security tab. For more information, please see the section ‘Preventing accidental erasing’ in chapter ‘Manual recording’.
[14PV235/ 21PV385]
No recording possible:
•‘VPS/PDC’ switched on but ‘VPS/PDC time’ wrong: enter ‘VPS/PDC time’ exactly to the minute. Check your aerial connection.
SMART Clock does not work:
•You have stored on programme number ‘P01’ a TV channel that does not transmit Teletext. Store on ‘P01’ a TV channel that transmits Teletext.
•Poor Teletext reception. Store a TV channel on ‘P01’ with good Teletext reception.
•You have not activated the SMART Clock func- tion. Switch the function ‘ON’.
You can also call the customer service centre in your country.
The telephone numbers can be found on page 16 of this operating manual. Have the model number (MODEL NO.) and the production num- ber (PROD. NO.) of your
15 | EN |
|