How to check or change a Timer

button on the remote control.

EXT. 1

button on the remote control.

cPress .

TIMER PROGRAMMING

VPS

DATEPROG. START END LP PDC REP.

,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,

15 xxx 15:36 15:50 - * ONCE

Store: press OK

d Select the entry field ’PROG.’ with the

button. Select ’Record prepared’ with the } or

zbutton.

eConfirm with the OK button.

Your TV-VIDEO Combi is now prepared for recording. The start and end of the recording is controlled via the scart cable.

f To end, press the TIMER button.

gPlace a cassette in the machine.

If you have not connected the satellite receiver yet, use a

scart cable to connect scart socket on the TV-VIDEO Combi to the corresponding scart socket on the satellite receiver.

hProgramme the satellite receiver with the required information (programme number on the SAT receiver, start time, end time).

The information on how to programme your satellite receiver can be found in the instruction manual for your satellite receiver.

Activating a recording from the SAT receiver with OTSR (OTSR = One Touch Sat Recording)

In the previous paragraph we described how to prepare the TV-VIDEO Combi for recording from the SAT receiver by means of the menu (step a through f ). OTSR will allow you to record a SAT programme fast and easy with just one button press.

a Press the

buttons at the same time until the

timer light on your TV-VIDEO Combi starts blinking. It will blink three times and will then stay alight.

Your TV-VIDEO Combi is now prepared for recording. The start and end of the recording is controlled via the scart cable.

Each time you programme a recording on the satellite receiver, you must prepare your TV-VIDEO Combi for recording. Each time you prepare your TV-VIDEO Combi for a satellite recording a TIMER-block will be reserved and the TIMER light at the front will blink.

If the TIMER light does not blink, you have not set the clock or all TIMER-blocks have been used up. Please read the paragraph ’Setting the time and date’ or ’How to clear a programmed recording (TIMER)’.

If you want to cancel the programmed SAT recording, follow the procedure described in the paragraph ’How to clear a TIMER’.

a Press the TIMER

bSelect the line ’TIMER PROGRAMMING’ with the

menu buttons } or z and confirm with the button.

cSelect the TIMER you want to check or change with the

}or z button and confirm with the OK button.

d Select the entry field with the

button.

e Change any information with the

button or

}

with the

buttons.

0-9

Under ’LP’, use the

button to select the

}

recording speed ’SP’ or ’LP’.

f Confirm with the

button.

g To end, press the TIMER button.

hMake sure that the cassette you have put in can be recorded on.

How to clear a TIMER

a Press the TIMER

bSelect the line ’TIMER PROGRAMMING’ with the

menu buttons } or z and confirm with the button.

cSelect the TIMER you want to clear with the menu buttons } or z .

dPress the CLEAR button.

e Switch off with the TIMER button.