Philips SVA104 On-Screen Status Displays, OFF mode Press the Display button once Count mode

Page 17

On-Screen Status Displays 17

You may access on-screen status displays by pressing the DISPLAY button repeatedly. On-screen status displays may include the current time, channel, and other information.

Press the DISPLAY button once. The COUNT on-screen status display will appear for five seconds. After five seconds, only the real-time counter will appear on-screen. This counter shows you the elapsed play- ing time of the tape (from the point at which the real-time counter was set to zero).

Press the DISPLAY button once again. The CLOCK on-screen status display will appear for five seconds. After five seconds, only the current time will appear on-screen (the clock must be set). (If you are watching TV, the current channel number will also appear on-screen.)

Press the DISPLAY button once again. The on-screen status display will disappear.

<OFF mode>

Press the DISPLAY button once.

<COUNT mode>

STOP

SLP 0:12:34

Press the DISPLAY button once.

<CLOCK mode>

STOP

5:40 PM

 

CH 02

Helpful Hints

SLP

Press the DISPLAY button once.

If the channel you select has no broadcast, the screen will be solid blue.

You may bring up a status display at any time by pressing the DIS- PLAY button. (The exception is when viewing a still picture or a slow motion picture, or when F.FWD or REWIND is pressed dur- ing playback.)

Channel numbers (when tuned) appear on-screen for a few seconds.

Image 17
Contents Video Cassette Recorder For Customer Use Warranty VerificationIntroduction FeaturesSafety Precautions Table of Contents Putting Batteries in the Remote Control Before Using Your VCRUsing the Remote Control VCR maintenanceDisconnect the antenna or cable from your TV Hookups Without a Cable Box / Direct Broadcast SystemPlug in the TV and the VCR CH3 CH4Recording/Viewing Any Channel ConnectionsRecording One Channel/Watching Another SignalCable Box/DBS CableHookups With a Stereo TV 2Turn on the TV Turning on Your VCRAutomatic Channel Setup Adding/Deleting Channels Automatic Channel Setup cont’dFollow the steps below to set your VCR’s clock. Make sure Setting the Clock96-7 Setting the Clock cont’dLanguage Selection Press the Counter RESET/EXIT button to exitOn-Screen Status Displays OFF mode Press the Display button once Count modePress the Display button once Clock mode Remote Control Buttons Eject Button Counter RESET/EXIT ButtonTime Search Button Index Search ButtonVCR Display Panel Front Panel Rear Panel AC Power CordVideo OUT Jack Video in JackRead and follow the steps below to play a tape Playing1Turn on the TV Insert a tape RecordingStopping an OTR One-Touch RecordingStarting an OTR Program Number → Once Daily Weekly Timer RecordingRepeat the procedure in to set the recording’s end time Timer Recording cont’d4Press the Counter RESET/EXIT button to exit Correcting a Timer Recording Cancelling a Timer RecordingAuto Return Auto Satellite Link Using a Satellite Tuner Recording One Channel/Watching Another Press the VCR/TV button on the VCR remote control toTo return to the channel being recorded, use the TV Put the VCR in VCR position. The VCR/TV light will appearAntenna Rerecording Tape DuplicationRepeat Play Forward and Reverse Searching SP/LP/SLP Special Effects PlaybackSuper High Speed Searching LP/SLP Viewing a Still PictureTo on or OFF Rental PlayMenu will disappear, and Rental on or Rental Press the Play button to watch the tape Real-Time Counter MemoryIndex Search Time Search is not available during recording Time SearchTo resume normal tape playback, press the Play button Quick FindAutomatic Playback Features Helpful Hints Helpful Hints cont’d Cable Box/DBS Output Channel Channel 3 or GlossarySpecifications Video Cassette Recorder Limited WarrantyIndex Supplied Accessories