Philips LTC 3963/51 manual Setup, Setting the Program Functions

SETUP

On-Screen displays are provided to aid setup of the programmable functions. The six functions on the Program Menu appear individually on the monitor in this order.

1.CLOCK SET

2.TIMER

3.SELECTION MENU 1

4.SELECTION MENU 2

5.ALARM

6.ALARM MEMORY

Note: If the VCR is not turned on for about 720 hours after the built-in battery is fully charged (after the VCR is turned on for more than 48 hours), the TIME/DATE display will be cleared.

SELECTING A FUNCTION TO BE PROGRAMMED The program menu will always begin with the CLOCK SET function, followed by the TIMER, SELECTION MENU 1, SELECTION MENU 2, ALARM, and then the ALARM MEMORY functions. Although the program menu always follows this order, it is possible to skip any of the available func-

CLOCK SET

TIMER DISPLAY

SELECTION MENU 1

SELECTION MENU 2

ALARM DISPLAY

ALARM MEMORY DISPLAY

CLOCK SET 

1–01–1999 FR I

0 : 00 :

OSD	OPT I ONS 
	TYPE :		OFF
T IME	ADJUST :		SLAVE
1 	0 : 00 a 0 : 00			09
2 	0 : 00 a 0 : 00			09
3 	0 : 00 a 0 : 00			09
4 	0 : 00 a 0 : 00			09
5 	0 : 00	a 0 : 00		09
6 	0 : 00	a 0 : 00		09
7 	0 : 00	a 0 : 00		09

MON:✽,✽ TUE :✽,✽ WED :✽,✽

THU :✽,✽ FR I :✽,✽ SAT :✽,✽

SUN:✽,✽

 SELECT I ON MENU 

V I DEO MODE :	AUTO
SEARCH SPEED :	X5
ONE SHOT REC :	6F I ELDS
BAUD RATE :	9600BAUD
CAMERA SW :	ALL

 SELECT I ON MENU 

BUZZER	SELECT I ON
TAPE END :	OFF
TROUBLE :	OFF
NO V I DEO :	OFF
AUTO REC CHECK : OFF
ALARM OUT :	OFF
ALARM SET 
DURAT I ON:	MANUAL
SPEED :	09
ALARM READY : YES
ALARM OUT :	DURAT I ON
RECYCLE	FUNCT I ONS 

REW I ND , STOP I F ALARM

ALARM MEMORY  A00

1

2

3

4

5

6

7

8

9

tions during the selection process.

To select the desired program function (and to move from one program function to the next), press the PROGRAM button repeatedly until the desired func- tion display format appears on the monitor.

After the desired function has been selected, follow the corresponding procedure to set that function.

SETTING THE PROGRAM FUNCTION(S)

The first step in each programming procedure is: “Press the START/STOP button”. The system allows up to five minutes for any one function set- ting to be completed after the START/STOP button is pushed. If no change/setting is entered within the five minutes period, the unit will automatically exit the selected program function. (If this happens, re- select the desired program function, and follow the programming procedure for that function.)

The following procedures for setting VCR functions assume that the desired function has already been selected.

Note: During programming, holding the SET, UP, or DOWN button will move/change the displayed infor- mation at a rapid rate.

Initial Program Function Display Formats

13