Tape Duplication

Connection

1Connect the recording VCR (this VCR) and the playing VCR.

2Connect the recording VCR (this VCR) to the TV.

Recording VCR (this VCR)

To AV1 IN/OUT Terminal

Dubbing from any VHS VCR (or video camera) to another is simple. Explanations on this page uses this VCR as the recording VCR.

Refer also to the manual supplied with the other VCR (for playback).

•You can also use the AUDIO/VIDEO input jacks on the front panel to connect another VCR or video camera.

• Use the appropriate SCART cable depending on the other VCR’s AV terminal.

Insert a source tape in the playing VCR and a blank tape in the recording VCR.

•If a tape without the record tab is inserted in the playing VCR, playback automati- cally starts. In this case, press the STOP button.

Press SPEED, pointing the remote control at this VCR, until the desired tape speed (SP, LP, or SLP) appears on the display.

SP, LP : For PAL signal.

SP, SLP : For NTSC signal.

5Play Back Tape

Press the PLAY 3button on the playing VCR.

To video	To audio	2At TV
	output	Turn the channel on the TV to your
output

video channel.

			Press CH 5or °, pointing the remote
			control at this VCR, to select the
POWER	STILL/PAUSE		external line input.
POWER	STILL/PAUSE		• For rear jacks, select “L-1” on the
			• For rear jacks, select “L-1” on the
	COLOUR	SP SLP	display.
	AUDIO
	MODE		• For front jacks, select “L-F” on the
			• For front jacks, select “L-F” on the
			display.

Press REC/OTR, pointing the remote control at this VCR.

Remember: press the buttons in steps 5 and 6 simultaneously to avoid missing any of the recording.

— 19 —

VR388/588-55 EN (N)

6/1/99, 9:04 AM