Audiovox PCD160U Manual Tuning Control FM Mono Select MON, Display Selector DSP, Mode Button Mode

PCD160U/PMP180U

OPERATING INSTRUCTIONS

6 Manual Tuning Control 9 FM Mono Select (MON)

pressed, it will activate one of the following modes: “FLAT”, “CLASSICS”, “POP M”, “ROCK

Turn the TUNING control (6) clockwise to tune upward in frequency on the band in use, or counter-clockwise to tune downward in frequency. The current frequency will be shown in digital format on the display panel. When tuning in a station, always adjust the control so that the correct broadcast frequency is shown on the display and you are receiving a clear signal. If the radio is tuned off-frequency, you could experience distorted audio, noise and other reception problems.

During FM radio operation, press the MON button (9) to select mono or stereo reception of the broadcast signal. Under normal reception conditions, the unit should be left in the stereo mode as indicated by the “ST” icon on the display panel when tuned to an FM stereo signal. If the stereo signal is too noisy for comfortable listening, press the MON button to switch to monaural reception. To return to stereo reception mode, press the button again so that the “ST” indication reappears.

M” or “DSP OFF”. When the Equalizer function is active, the bass and treble levels can still be changed to accommodate the listener’s ear.

When the EQ function is not active, the unit returns to the user-set bass and treble levels.

18Display Selector (DSP)

This unit can display either the clock time or radio frequency/CD player functions. Ordinarily, the radio frequency or CD player track indication is displayed, but the unit will display

7Mode Button (MODE)

Press the MODE button (7) to change between radio, CD or CD Changer play. When a CD is playing, you can press this button to revert to radio operation.

8Audio Mute (MUTE)

Press the MUTE button (8) to mute the volume from the system. “MUTE” will appear on the display panel and the volume will be muted. Press the MUTE button again, turn the MULTI/ JOG control (3), or press the SEL/MENU button (4) to return the volume level to the setting in use before the Mute function was activated.

10Local Button (LOC)

During radio operation, received signals are usually in stereo mode as indicated by the “ST” icon; however, when the signals are weak or intermittent, you can activate the Local (LOC) mode by pressing the LOC button (10). “LOC” appears on the display. This mode favors access to local stations whose signals are much stronger; thereby improving radio reception. Press the LOC button again to terminate Local receive mode (“LOC” disappears from the display panel).

11Equalizer Selector (EQ)

The EQ button (11) applies preset sound effects to the unit’s audio output signal. When

the time when the DSP button (18) is pressed. The time will display for approximately 5 seconds then return to the radio or CD player function display. The correct time-of-day can be set by pressing and holding the DSP button.

Setting the Clock

To set the clock, perform the following steps:

1.Turn the vehicle ignition and radio on.

2.Press and hold the DSP button (18) until the time display flashes.

3.Within 5 seconds, turn the MULTI/JOG control (3) clockwise to adjust the minutes to the desired setting.

4.Turn the MULTI/JOG control counter- clockwise to adjust the hour and the “AM”/ ”PM” indication to the desired time.

9