Assembly
IMPORTANT! Before assembly and each use, inspect this product for damaged hardware, loose joints, missing parts or sharp edges. DO NOT use if any parts are missing or broken. Contact
Base
Frame
1
•Insert and “snap” the base into the sockets in each side of the frame, as shown.
Hint: The base is designed to fit one way. If it does not seem to fit, turn it around and try again.
Swing Arm 
Frame Tube
2
•Position one of the swing housings so that the swing arm is facing the inside of the assembly.
•Fit the swing housing onto the frame tube.
Hint: The swing housing is designed to fit one way. If it does not seem to fit, try assembling it to the other frame tube.
3
•Insert an M6 x 25 mm screw into the hole in the swing housing. Fully tighten the screw with the Allen wrench.
•Repeat this procedure to assemble the remaining swing housing to the other frame tube.
Seat Back
Seat Bottom
Tabs
4
• Fit the tabs on the seat bottom into the slots in the seat back.
3