Assembly

IMPORTANT! Before assembly, inspect this product for damaged hardware, loose joints, missing parts or sharp edges. DO NOT use if any parts are missing or broken. Contact Fisher-Price® for replacement parts and instructions if needed. Never substitute parts.

Front Legs

(Longer)

Tapered End

Press

Button

Press

Button

Tapered End

Front Base

•Place the front base on a flat surface.

•Position a front leg (longer) so that the tapered end is downward, as shown.

•While pressing the button on one of the front legs, insert it into the front base. Push down on the front leg until the button “snaps” into the hole in the front base.

•Repeat this procedure to assemble the other front leg to the front base.

Housing	Hub
Slot	Motor
	Motor
	Housing
	Press
	Buttons

Front

Legs

•Position the housing so that the hub is inward.

•While pressing the button on the top of front leg, insert it into the housing slot, as shown. Push the front leg until the button “snaps” into the hole in the housing.

•Repeat this procedure to assemble the motor housing to the other front leg.

•Pull the front legs down to be sure they are secure in the housings. If you can remove them, you have not assembled them correctly. Please re-read and repeat this assembly step.

	Motor Housing
	Short Tube
Pull Up	Button
Front Legs	Pull Up
Front Legs

Tapered

End

			Rear Legs
			4
2	Front Base		• Position a rear leg so that the tapered end is upright.
2			• Position a rear leg so that the tapered end is upright.
			• While pressing the button on the top of the rear leg, insert it
			into the housing short tube, as shown. Push the rear leg
• While standing on the front base, pull the front legs up.			until the button “snaps” into the hole in the short tube.
• While standing on the front base, pull the front legs up.			• Repeat this procedure to assemble the other rear leg to the
The front legs should remain secured to the front base.
The front legs should remain secured to the front base.			motor housing short tube.
If you can remove the front legs, you have not assembled			motor housing short tube.
If you can remove the front legs, you have not assembled			• Pull the rear legs down to be sure they are secure in the
them correctly to the front base. Reread and repeat			• Pull the rear legs down to be sure they are secure in the
assembly step 1.		4	housings. If you can remove them, you have not assembled
		4	them correctly. Please re-read and repeat this assembly step.