Assembly
Seat Wire
Slots
13
•Lift the seat tubes slightly.
•With the seat wire hanging down, insert the ends of the seat wire through the slots in the seat, as shown.
Rounded Edge Up
Seat Wire |
| |
Cap Hole |
| |
14 Cap | Ends of | |
Seat Wire | ||
Seat Wire | ||
| Seat Wire Cap |
•While holding the seat wire in place, carefully turn the seat around so that the front faces you.
•Position the seat wire cap so that the rounded edge is upright.
•Fit each end of the seat wire through the hole in each seat wire cap.
Press in Place
Seat Wire is
Through Hole in
Seat Wire Cap
Seat Wire
15
Caps
• Press the seat wire caps
into place. | #6 x 5/8" Screw - 4 |
• Insert two #6 x 5/8" screws | Shown Actual Size |
through each seat wire cap |
|
and tighten. |
|
Hint: The seat wire caps are designed to fit into the seat only one way. If the screw holes in the seat wire caps do not align with the holes in the seat, try switching the seat wire caps onto the opposite ends of the seat wire.
Accessory Bin | Accessory Bin |
|
Grooves |
16
Seat#8 x 13/8” Screw - 4
Shown Actual Size
•Turn the seat face down.
•Fit an accessory bin into the groove on each side of the seat, as shown.
•Insert two #8 x 13/8" screws into each accessory bin and tighten.
7