Sunrise Medical Xpress Pelvic Positioning Belt Position Adjustment, Butterfly Harness

Page 31

v i i . o p e r at i n g i n s t r u c t i o n s

V.PELVIC POSITIONING BELT POSITION ADJUSTMENT

For the standard seat configuration the belt is always adjusted to the rear most point (approximately 45°). When the contour seat cushion is used, the belt may be adjusted forward to achieve an adjustment of up to 90°.

1.Loosen the attachment screw one or two turns to allow the belt anchor point to slide in the slot. (See Fig. 24)

2.Move the belt to the desired adjustment position (leave in the rear most position when the standard seat configuration is used).

3.Tighten the screw securely.

Note: Install the nylon web strap wraps under the tube,

 

 

beside the seat base, and back over the top of the tube.

Figure 24

This keeps the belt in the outer most position so it does

 

not interfere with the seat cushion.

 

 

W. BUTTERFLY HARNESS

! WARNING

To avoid serious injury or problems with eating or breathing, the pelvic positioning belt must be used in combination with the butterfly harness. Make sure any needed adjustments are made to ensure that there is no possibility of obstructing the airway or any other undesired constrictions. Do not use the butterfly harness without the pelvic positioning belt.

 

 

 

 

 

 

 

 

 

 

 

 

 

Figure 25

 

 

 

 

 

 

Figure 26

 

 

 

 

 

 

Harness Adjustment

1.Place child in the seating system and fasten the pelvic positioning belt.

2.Position the child's hips and tighten the pelvic positioning belt to the proper position.

3.Connect the butterfly harness to straps already fastened to the positioning shell. (See Fig. 25)

4.First, adjust the lower butterfly straps to keep the butterfly from riding up on the child's torso.

5.Then, adjust the upper straps making sure there is enough room around the child's neck for easy breathing and eating. (See Fig. 26)

6.Once the butterfly straps are adjusted, snap the lower straps into the plastic tri-glide up against the quick release buckle.

31

mkt3048 9921700000 Rev C

Image 31
Contents Kid Kart Xpress Page T. Group Listens N T R O D U C T I O NIntroduction T a B L E O F C O N T E N T SVIII. Maintenance IX. Limited Warranty Tilt in space adjustment mechanism I . Y o u r X p r e s s a n d i t s p a r t s Getting to Know Your Xpress Safety ChecklistChanges & Adjustments G e n e r a l w a r n i n g sNever use the mobility device shell as a car seat Motor Vehicle SafetyEnvironmental Conditions Street USEFor Caregivers Transit USE A r n i n g s f o r s a f e u s eReaching or Leaning Center of BalanceDressing or Changing Clothes ObstaclesTransfers RAMPS, Slopes & Side HillsCurbs & Steps Descending Stairs MaintenanceTo climb a step or curb going Forward Climbing StairsTray supports W a r n i n g s f o r c o m p o n e n t s & o p t i o n sTransit Option ANTI-TIP TubesPositioning Belts FastenersFootbeds TiresUpholstery Fabric Power DriveQUICK-RELEASE Axles Wheel LocksI . o p e r at i n g i n s t r u c t i o n s Wheel Lock AdjustmentUnfolding Your kid kart is equipped with two stage folding Folding Frame and Rotating Handle Into Storage PositionC2. Handle only folding See C1. TWO Stage FoldingC3. Folding Frame complete Rear Wheel Removal and Installation Forward Position Reversed Position Positioning Shell InstallationPositioning Shell Removal HIP Angle Adjustment for Karts without TILT-IN-SPACE TIS Angle AdjustmentRecline Adjustment optional Sunshade Installation and Adjustment Knee Angle AdjustmentSeat Depth Adjustment Positioning and Growth Adjustments GuideContoured Seating System Cushion Adjustments Standard Seat Cushion AdjustmentStandard Cushion without Lateral Hip Support Back Cushion Height Adjustment Back Positioning Plate Height AdjustmentFootbed Adjustments Pelvic Positioning Belt Length Adjustment Butterfly Harness Pelvic Positioning Belt Position AdjustmentLateral Trunk Supports optional Assembly to the Seating ShellLateral Rotation Adjustment See Operating and AdjustmentLateral Height and Width Adjustment See Lateral Length Adjustment SeeAttaching Head Support See Whitmyer Head SupportsAttaching Head Rest Pad See Patent Pending Forehead Strap Adjustment InstallationDownward Stop Angle Adjustment CC. Knee Adductors optional BB. HIP Pads optionalEE. tray support Adjustment DD. Knee Abductor Block Adjustment optionalFF. Tray Installation and ADJUSTMENToptional HH. Shoe Holder Strap Adjustment optional GG. Foot Strap Adjustment optionalI i . m a i n t e n a n c e L i m i t e d w a r r a n t y T E S T E S T. Group is a division of Sunrise Medical