v i i . o p e r at i n g i n s t r u c t i o n s
Y. LATERAL TRUNK SUPPORT MOUNTING (optional)
OPERATING AND ADJUSTMENT.
Lateral Swing Away Operation: (See Fig.3)
1.Depress the silver lever (a) (See Fig.3) allowing the lateral to swing inwards or outwards. This is useful for storage or helping a child into or out of the seating system.
NOTE* the laterals lock into the adjusted preset position.
Lateral Height and Width Adjustment: (See Fig.1) page 32
NOTE* It is not necessary to remove the child from the seating shell.
1.Open the rear cover to access the adjustment screws.
2.Loosen the mounting screws (a) (See Fig.1) page 32 from the rear of the shell only enough to gain movement of the laterals. Adjust the pads for height and width bringing the pads to the correct position.
3.Tighten firmly.
Lateral Length Adjustment: (See Fig.4)
1.Slide the lateral cover and foam forward or remove to expose adjustment screws
2.Loosen screws (b) and move lateral to proper length
3.Tighten screws and replace the foam and cover. Lateral Lock Angle Adjustment
Note* this adjustment may be able to be accomplished with the child in the seating system.
Lateral Rotation Adjustment: (See Fig.5)
1.Lock the lateral by rotating inwards
2.Loosen the angle lock screw (c) (See Fig.5) shown on the top of the lateral hinge point
3.Adjust angle to the appropriate position and tighten.
Figure 3
B
Figure 4
C
Figure 5
33
mkt3048 9921700000 Rev C