SC362 page 4
1. GENERAL
English
CONTENTS |
| |
1. | GENERAL | 4 |
2. | QUICK REFERENCE | 4 |
3. | POWER SUPPLY | 4 |
4. | OPERATION | 5 |
| TECHNICAL SPECIFICATIONS | 24 |
| ILLUSTRATIONS | 3 |
INTRODUCTION
Congratulations! You have just purchased a truly cordless Baby phone (SBC SC362) that enables you to monitor your child from wherever you are in and around your house. The Baby phone has been tested to meet all necessary regulations and standards, and features a battery
Note: While the Baby phone is intended as an aid, it is not a replacement for real parent supervision and should not be used as such.
2. QUICK REFERENCE
QUICK REFERENCE
1.Connect one of the enclosed mains adapters to the ‘baby unit’ and the other to the ‘parent unit’ standing base (fig. 2).
2.Set the ‘baby unit’ to VOICE mode (fig. 1.4) and place it near the baby’s bed.
3.Place the ‘parent unit’ in the standing base (fig. 2).
4.Switch the ‘parent unit’ to ON to an acceptable sound level (fig. 1.2).
–Every time sound is detected from or near the baby, it is transmitted to the parent’s unit.
5.Adjust the sound level on the ‘parent unit’ as required.
3. POWER SUPPLY
MAINS POWER SUPPLY
•Check that the mains voltage as indicated on the mains adapter corresponds to your local mains voltage. If it does not, consult your dealer or our service organisation.
•Connect a mains adapter to the ‘baby unit’ as indicated in fig. 2.
•Place the ‘parent unit’ inside the standing base and connect a mains adapter as indicated in fig. 2.
–If the mains power adapter is connected correctly, the red ADAPTER LED on the standing base lights up.
BATTERY POWER SUPPLY (batteries not enclosed)
•Install batteries inside ‘baby unit’ as indicated in fig. 3 for cordless ‘baby unit’ operation.
•Install batteries inside ‘parent unit’ as indicated in fig. 3 for cordless ‘parent unit’ operation.
Notes
–Both the ‘baby unit’ and ‘parent unit’ have a ‘battery low’ indication. If the batteries are low the unit beeps and the red POWER LED starts flashing.
–Remove the batteries from the ‘ baby unit’ and the ‘parent unit’ when they are not going to be used for a long period of time.
–To conserve batteries, connect the units to the mains by using the enclosed mains adapters.
–If batteries are installed and the mains power adapters are connected, the units operate on mains power. In the event of a mains failure, the batteries will take over.
–Replace batteries with original PHILIPS LR6 POWERLIFE batteries only.
4