JOGGING CTS KIT
3.0 Installation
Remove any other conversion kits from the wheel wheel arm attachment bracket. Insert the wheel arms by pressing the small button and sliding the arm into the wheel arm attachment bracket. The large button should engage into the hole on the wheel arm attachment bracket.
WHEEL ARM
WHEEL
BRACKET
QUICK RELEASE LEVER
Close the quick release lever by pushing it flat against the wheel bracket. When the nut is properly adjusted, you will feel resist- ance halfway through tightening the lever. Make sure the lever is closed towards the back of the
carrier.
WARNING:
Failure to properly attach wheels could cause the wheels to fall off, resulting in an accident and serious injury.
Install the quick release axle through the wheel’s hollow axle with a spring on each side of the wheel. Screw the nut onto the other side of the skewer axle.
WARNING:
Overloading the carrier with more than 2.2lb (1kg) in the rear storage pouches can make the carrier unstable.
Slide the wheel axle all the way into the wheel bracket dropouts.
With the quick release lever opened 90o to the wheel brackets (ie. pointing straight out),
WARNING:
The following safety precautions should be followed otherwise injury or death to you or to your passengers could result:
–Use wrist safety straps at all times.
–Always use seat belts.
–Always use parking brake when stroller is stationary.
–Never
–Never climb or descend stairs with the jogging kit.
–Use extreme caution on hills.
14