1.7 Adjusting the Rear Cargo Bag
There are two positions available for the rear cargo bag. The bag can be folded up if not used, or dropped down to easily fill the bag with contents.
To lower or raise the bag, release the quick release skewer on the side of the carrier located just above the top of the wheel.
There are 2 stops built into the mechanism. Either pull the bag down until level with the ground, or push the bag up until the bag will not fold any more. Tighten the quick release skewer, only in either of these positions, by closing it towards the rear of the carrier.
1.8 Parking Brake Instructions (Cougar models only)
The parking brake is located at the center of | Engage the parking brake by pressing the | Disengage the parking brake by lifting the |
the rear axle under the rear storage bag. | plunger down on the brake housing. | plunger upwards. |
1.9 CX Drum Brakes (CX models only)
The brakes on all CX carriers act as an active brake to help regulate your speed when moving and also as a parking brake. It is very impor- tant to keep the brakes adjusted so that the brakes function properly in both circumstances.
Basic Operation
The brake system provided on the CX carri- er is a drum brake system. The brakes located on the end of the carrier’s rear axle expand, contacting the inside of the rear wheel’s hubs, causing the carrier to slow down. Periodic adjustments are required to ensure proper contact between these sur- faces.
Braking conditions will vary based on out- door conditions. For example when the brakes get wet, more force will need to be applied to the hand lever to get the same braking results as in dry conditions. Keep this in mind when using your carrier and before making adjustments to the brakes.
Note the location of the cable guide adjust- ments. Please see your local dealer with any concerns regarding adjusting these brakes.
When uprighting and folding your carrier, the brake cable ends can shift out from its guides. When this occurs, it will be difficult to place your wheel onto the carrier as the brake is partially applied.To fix this problem, simply apply the brakes by squeezing the hand lever when the carrier is in its upright position.
7