X-COUNTRY SKIING CTS KIT
5.0 Installation
Remove any other conversion kits from wheel arm attachment brackets. Insert X- Country skiing arms into the wheel arm attachment brackets and secure using safety snap pins.
5.1 Shoulder Harness Adjustments
The waist belt comes adjusted in the largest setting, however you may adjust to a narrow- er setting by removing the bolts and reattach- ing them to the rear grommets.
Securely attach the waist harness around your waist with the buckle in front and the poles adjusted to your hip area.
Insert the
WARNING: Failure to properly attach XC skiing kit arms and axles could cause the carrier to separate from you, resulting in an accident and serious injury or death.
Adjust the length of the XC skiing kit arms by sliding the inner tube out until the hole on the inner tube lines up with the hole on the outer tube. Insert securing pin.
Note: The arms have 3 adjustment positions.
Because of the unique axles used on the CX carrier, a separate steel axle adapter kit is required. This kit needs to be
WARNING:
Read and understand all of the warnings otherwise injury or death to you or to your passengers could result:
-Only an experienced skier should use the
-Do not exceed the maximum load recommended for your carrier. Important: This weight may be too heavy for some skiers.
-The extra length and width of the XC skiing kit will require additional attention while passing others on the trail or skiing on narrower trails.
-Always use seat belts.
-Never leave children unattended in carrier.
-Regularly monitor your children to ensure they are comfortable and warm.
-Do not
-Never use your
-Use extreme caution on hills, aggressive trails, and when stopping!
-Take the
-Make sure the length of the arms on your XC skiing kit are adjusted correctly, to ensure that your skis or poles will not be in contact with the carrier.
18