on the stroller version of Pramette (when the zip is open the elastic loops ensure that the rain canopy remains fastened to the stroller).
43• This rain canopy is also designed for use when the Primo Viaggio car seat is hooked onto the stroller, ensuring total protection.
44• The figure shows the rain canopy on the carriage version of Pramette.
45• The figure shows where to fasten the rain canopy button and elastic band on the Pramette carriage version.
46• The figure shows the lowered rain canopy on the carriage version of Pramette (when the zip is open the elastic loops ensure that the rain canopy remains fastened to the stroller).
•Do not use the rain canopy indoors and always check to be sure that your child is not too hot.
•Do not place the PVC rain canopy near sources of heat and pay attention to cigarettes.
•Verify that the rain canopy cannot interfere with any moving mechanism of the chassis or stroller.
•Always remove the rain canopy before closing your chassis or stroller.
•Wash with a sponge and soapy water without using any detergent.
CLOSING
Before closing the stroller, loosen the braces if the hood is attached, and raise the backrest if it is lowered.
47• The stroller can be closed with one hand: pull first one lever up and then the other until it releases.
48• Grip the central handle and pull it upward
until it closes, as shown in the figure. 49• Verify the correct closing of the stroller
from the safety hook. The folded stroller can stand upright.
50• Pliko
TRANSPORT
51• The stroller can easily be carried (lock the swivelling front wheels) by gripping the central handle, as shown in the figure.
52• You can also use the side handle to carry it, as shown in the figure.
REMOVABLE LINING
53• To remove the strollerʼs lining, loosen the fasteners on the armrests as shown by the arrows.
54• Unbutton the sack at the side, as shown in the figure. Slip the leg divider on the
safety belt out from under the seat. 55• Unscrew the strap (only on one side) as
shown in the figure, holding your finger under the nut.
56• Unbutton the sack from the seat, and slip it off the hooks on the footboard.
57• Slip the sack off the side of the backrest, as shown in the figure.
58• Slip the previously loosened strap through the slit in the sack, as shown in the figure.
59• Remove the sack and wash it, following the instructions given here.
•To remount the sack on the stroller, carry out the instructions in the reverse order, making sure to screw the strap back into place.
GANCIOMATIC SYSTEM
The Ganciomatic System is the swift, practical system that allows one to fasten to the stroller, with Ganciomatic fasteners, the car seat Primo Viaggio, which can be bought separately and is also equipped with Ganciomatic System. Primo Viaggio can be detached from its base (which stays in the car) and attached to the Ganciomatic fasteners of the stroller to transport your child without disturbing him/her.
STROLLER GANCIOMATIC HOOKS 60• To raise the Ganciomatic hooks on the
stroller, pull the sack up at the corners of the seat and turn the two hooks upwards until they click into place.
61• To lower the Ganciomatic hooks on the stroller, pull the little lever outwards and turn the hooks upwards at the same time, as shown in the figure.
•Lower the Ganciomatic fasteners if, afterwards, you use Pliko
PLIKO P3 PRAMETTE + PRIMO VIAGGIO
•Fasten “Primo Viaggio” onto Pliko P3- Pramette in the stroller version.
62• To fasten the car seat to the stroller:
-set the brake on the stroller;
-remove the hood from the stroller;
-completely lower the backrest on the stroller;
-raise the Ganciomatic hooks on the stroller;
-place the car seat, turned towards the adult, on the stroller and push downward until it clicks into place;
-Do not remove the front bar of the stroller when attaching the car seat,
and make sure that it is in its original position;
•See the userʼs manual for instructions on how to detach the car seat from the stroller.