To recline seat:
To fully recline, unhook buckle on back of the seat (Figure I).
To place seat in upright position, push seat forward and reconnect buckle located on back of seat. Extra webbing can be placed in the rear pouch so it does not hang down and drag.
To adjust the recline position, adjust the buckle on the strap.
WARNING: Child may slip into leg openings and strangle. Never use in a reclined car- riage position unless the
Step 9. Using the infant car seat adapter bar
When the car seat adapter bar is properly installed onto “The Everyday Stroller,” it is designed to be used with the following infant car seat brands and models. Graco® Snug Rider,® Century® Avanta,® Evenflo® On My Way.®
The trade names and trademarks of Graco,® Century,® and Evenflo® are the trademarks of their respective companies.
WARNING: Failure to follow these warnings and assembly instructions could result in serious injury or death.
The front child tray must be removed before using the infant car seat adapter bar.
Lift up the textile cover of the seat’s side tubes. Insert adapter bar with buttons on the inside. Push in the spring buttons while pushing adapter bar into the seat’s side tubes end (Figure J1). Release but- ton and continue pushing in the bar until the spring buttons lock into the holes located on the inside of the seat’s side tubes. Pull on bar to make sure it is locked in place.
To remove adapter bar push in spring buttons with your finger or pen and pull out the bar. Store adapter bar in the under seat basket when not in use (Figure J2).
I
Rear Recline
Strap
Black | J1 |
Spacers |
|
Car Seat
Adapter Bar 
Spring Lock
Buttons
Textile
Cover
J2
Adapter Bar
Under Seat
Basket
6