InStep SS100 FrontWheel Assembly, To lock the front wheel from turning, Front Fender Assembly

Page 4

Step 3. FrontWheel Assembly

Turn stroller upright onto its rear wheels, then tip stroller back so the handlebar is down on the ground and the front is up. Slide the front wheel assembly onto the front wheel post, push until the wheel assembly locks into place (Figure C1). Check to see that the wheel assembly is properly inserted by pulling on the wheel firmly. To remove wheel push on release tab and pull off wheel (Figure C2).

To lock the front wheel from turning:

Push down on the front wheel’s lock lever to keep the front wheel from turning. To unlock, lift up on lever (Figure C3).

C1

Front Wheel Post

Front Wheel Assembly

Step 4. Front Fender Assembly

While stroller is still upright on its rear wheels, align the fender’s tabs with the holes in the front frame and press on. Insert the #4 – 16mm screws into the hole and tighten with a Phillips screwdriver, repeat for the other 3 holes (Figure D).

WARNING: To avoid burns, never put hot liquids in the parent or child tray. To prevent tipping over do not place more than 2 lbs. or 1 kg on either parent or child tray.

C2

Front Wheel

Release Tab

C3

Front Wheel

Lock Lever

D

Fender

Tab

Front Frame Fender Holes

4

Image 4
Contents Operating Instructions Safety Rules Saturn StrollerModel SS100 and SS150 Saturn Stroller Assembly Instructions Stroller Assembly and Use InstructionsParts List Unfold StrollerRearWheel Assembly To engage rear brakesFront Fender Assembly FrontWheel AssemblyTo lock the front wheel from turning Installing ChildTray Installing Parent’s Convenience TrayAdjusting Handle Height Proper use of Seat Belt Shoulder Straps, and ReclineUsing the infant car seat adapter bar To recline seatMounting infant car seat onto the adapter bar Care and Maintenance To clean seat and canopyTo clean frame Check fasteners