Mounting infant car seat onto the adapter bar
Note: The stroller seat should be in the full recline position with the recline strap unbuckled prior to placing car seat on. With the car seat adapter bar installed on the stroller, position the infant car seat (WITHOUT CHILD) so its mounting notch aligns with bar. The car seat will be mounted rearward facing towards the handle of the stroller. Push firmly down on the car seat so the bar is in contact with the car’s seat locking device or mounting notch (Figure J3). Note: Some car seats do not lock onto the bar, they just rest on the adapter bar. Using the stroller’s recline strap reverse the strap and insert the recline strap around the tubing and slide into the car seat’s retention slots on both sides of car seat and buckle (Figure J4). Cinch tight the recline strap around the car seat to anchor in place (Figure J5). Check to make sure the car seat is mounted securely by rocking the car seat front to back. The car seat should not wobble. If it does check and adjust the tension of the recline/restraint strap and make sure that the car seat mounting notch is resting on the adapter bar (Figure J6).
DO NOT CHECK THE CAR SEAT MOUNTING TO THE STROLLER WITH YOUR CHILD IN THE CAR SEAT.
WARNING: Car seats may fall forward if the strollers retention strap is not used. Do not use the car seat without cinching tight the retention/recline strap around the car seat.
J3
Car Seat Locking
Mounting Notch
Adapter
Bar
J4
Strap Around
Frame Tube
Only – Do
Not Wrap
Over Canopy
Tube
Car Seat
Retention
Slot
J5
Car Seat
Retention
Slot
J6
NOTE:
For the Century Avanta models, remove the
7