Baby Trend 7311 manual Installation of the Graco Snug Ride Infant Car Seat

Graco Snug Ride®

Please follow the following instructions for proper installation of your infant car seat.

Installation of the Graco® Snug Ride® Infant Car Seat

1.Place front seat in the reclined position. With one hand grasp the car seat handle (in its upright, carrying position) and gently place the seat, so that the baby faces the rear of the Stroller, onto the Snap-N-Go attachment system so that the large groove on the seat bottom, nearest the head-end of the seat, hooks over the Snap Bar. Check that the seat locked onto the Snap Bar.

2.Move Car Seat Straps to the rear location as shown in Figure 2. Feed the Car Seat Straps through the auto belt slots on the infant car seat and snap the two buckles together (see Figure 3). The first time you do this, you will need to adjust the length of the strap for a tight fit around the car seat. FOR SAFE

OPERATION, IT IS VERY IMPORTANT THAT THE CAR SEAT STRAP IS ALWAYS TIGHTLY FASTENED OVER THE CAR SEAT.

3.Test for secure installation by moving the car seat in all directions. The car seat should be securely attached to the stroller.

Removal of the Graco® Snug Ride® Infant Car Seat

1.Unlock the Car Seat Strap and remove from over the infant car seat.

2.With one hand, grasp the car seat handle (in its upright, carrying position) and with your other hand squeeze the red handle on the back of the car seat and lift the car seat upward from the Snap- N-Go frame.

Position “1”

Snap Bar

Position “III”

Figure 1.

Figure 2.

Cosco®, Peg Perego®, Primo Viaggio®, Evenflo®, Cozy Carry®, On my Way®, Embrace®,
Century®, Vante®, Graco®, Cosco® Arriva® and Snug Ride® are the trademarks of their owners.
They are not associated with Baby Trend, Inc. and no approval or endorsement is implied.	17