Baby Trend 1304TW manual Installation Instructions for Evenflo On My Way

Installation Instructions for Evenflo® On My Way

The Double Snap-N-Go®will accommodate the Evenflo® On My Way Infant Car Seat. Please follow the following instructions for proper installation of the On My Way.

Front Seat:

1.Remove (unscrew) Crossbars A1, C, B1 and D from the Double Snap-N- Go® frame. Remove the Car Seat Straps from the Double Snap-N-Go®frame. Retain the screws you remove.

2.Attach Crossbar B1 with sleeve to the Double Snap-N-Go®frame using the two holes labled #4 as shown in figure 1. use the two screws that you removed in step 1.

3.Attach Crossbar C to the Double Snap-N-Go®frame using the two holes labeled #6 as shown in figure 1. Use the two screws that you removed in step 1.

4.Attach the Car Seat Straps to the Double Snap-N-Go®frame using the two holes labeled 5 as shown in figure 1. Use the two screws that you removed in step 1.

Rear Seat:

1.Remove (unscrew) Crossbars A2, B2, and B1 from the Double Snap-N- Go® frame. Retain the screws you remove.

2.Attach Crossbar B2, so that the bent section faces down, to the Double Snap-N-Go®frame using the two holes labeled #3 as shown in figure 2. Use the two screws that you removed in step 1.

Insertion of the Evenflo® On My Way Infant Car Seat

1.With one hand grasp the car seat handle (in its upright, carrying position) and gently place the seat, so that the baby faces the rear of the Double Snap-N-Go®, onto the Double Snap-N-Go®so that the large groove on the seat bottom, nearest the head-end of the seat, hooks over Crossbar C in the front or crossbar B2 in the rear. Check that the seat locked onto the Crossbar. See Figure 3. FOR SAFE OPERATION, IT IS VERY

IMPORTANT THAT THE SEAT LOCK SECURELY ONTO THE CROSSBAR.

2.Feed the Car Seat Straps through the auto belt slots on the infant car seat as shown in Figure 4 and snap the two buckles together. The first time your do this, you will need to adjust the length of the strap for a tight fit around the car seat. FOR SAFE OPERATION, IT IS VERY IMPORTANT

THAT THE CAR SEAT STRAP IS ALWAYS TIGHTLY FASTENED OVER THE CAR SEAT.

3.Test for secure installation by moving the car seat in all directions. The car seat should be securely attached to the Double Snap-N-Go®.

Removal of the Evenflo® On My Way Infant Car Seat

1.Unlock the Car Seat Strap and remove from over the infant car seat.

2.With one hand, grasp the car seat handle (in its upright, carrying position) and with your other hand squeeze the red handle on the back of the car seat and lift the car seat upward from the Double Snap-N-Go®frame. See Figure 5.

Evenflo® and On My Way are the trademarks of their owners. They are not

associated with Baby Trend and no approval or endorsement is implied.

Hole #6		Hole #4
	Hole #5
Bar C		Bar B1
	Strap	Sleeve
	Fig. 1

Hole #5
	Hole #3
	Bar B2
Strap	down
	Fig. 2

Fig. 3

Fig. 4

Fig. 5 11