Baby Trend 1304TW guide

Installation Instructions for Cosco® Designer/Opus 35

The Double Snap-N-Go®will accommodate the Cosco® Designer/Opus 35 Infant Car Seat. Please follow these instructions for proper installation of the Cosco®.

Front Seat:

1. Remove (unscrew) Crossbars A1, C and D from the Double Snap-N-Go®

frame. Leave Crossbar B1 in hole labeled #4. Remove the Car Seat Straps

from the Double Snap-N-Go®frame. Retain the screws you remove.

2. Attach Crossbar B1 (removed from the rear section of the Double Snap-

N-Go®frame), so that the bent section faces down, to the Double Snap-N-

Go® frame using the two holes labeled #5. Use the two screws that you

removed in step 1. Please see figure 1.

3. Attach both Car Seat Straps to the Double Snap-N-Go®frame using the

two holes labeled #3. Use the two screws that you removed in step 1.

		Hole #3
Hole #5		Hole #4
		Strap
Bar B1		Bar B1
Bar B1
down
	Fig. 1
Hole #4		Hole #1
Hole #4		Hole #3
		Hole #3

Bar B2

Please see figure 1.

Rear Seat

Bar C

Strap

1.Remove (unscrew) Crossbars A2 and B1 from the Double Snap-N-Go®frame. Remove the Car Seat Straps from the Double Snap-N-Go®frame. Retain the screws you remove.

2.Attach Crossbar C (removed from the front section of the Double Snap-N- Go® frame) to the Double Snap-N-Go®frame using the two holes labeled #4. Use the two screws that you removed in step 1. Please see figure 2.

3.Attach both Car Seat Straps to the Double Snap-N-Go®frame using the two holes labeled #1. Use the two screws that you removed in step 1. Please see figure 2.

Insertion of the Cosco® Designer/Opus 35 Infant Car Seat

1.With one hand grasp the car seat handle (in its upright, carrying position) and with your other hand squeeze the handle on the back of the car seat and gently place the seat, so that the baby faces the rear, onto the Double Snap-N-Go®so that the rear small grooves on the seat bottom hook over Crossbar B1 for the front position or Crossbar C for the rear position. Release the handle and check that the seat locked onto the bar. See Figure 3. FOR SAFE OPERATION, IT IS VERY IMPORTANT

THAT THE REAR LATCHES OF THE SEAT LOCK SECURELY ONTO THE CROSSBAR.

2.Feed the Car Seat Straps through the slots found on the rear of the Car Seat shell as shown in figure 4. Buckle the two straps together. The first time your do this, you will need to adjust the length of the strap for a tight fit around the car seat. Please see figure 4.

3.Test for secure installation by moving the car seat in all directions. The car seat should be securely attached to the Double Snap-N-Go® .

Removal of the Cosco® Designer/Opus 35 Infant Car Seat

1.Unlock the Car Seat Strap and remove.

2.With one hand, grasp the car seat handle (in its upright, carrying position) and with your other hand squeeze the handle on the back of the car and lift the car seat upward from the Double Snap-N-Go®. See Figure 5.

Cosco® and Designer/Opus 35 are the trademarks of their owners. They are not associated with Baby Trend and no approval or endorsement is implied.

Fig. 2

Fig. 3

Fig. 4


Fig. 5	9