Hoist Fitness CL-2403 owner manual 8-16 x 2 3/4 Flat Head Cap Screw White Zinc

A SS E M B LY

I N S T R U C T I O N S

Step 2f

F R A M E A S S E M B L Y

In this step start by pressing the two Guide Rod Bushings into the Weight Cage. Take the two Weight Bumpers and place them over the two holes in the bottom of the Weight Cage. Now slide the Guide Rods into the holes. Make sure the Guide Rods are lube with Spindle Oil. Now, slide (20) 20 LBS. Intermediate Weight Plates and the (1) 41 LBS. Steel Top Plate onto the Guide Rods. Make sure the Weight Stack and its Guide Rods are sitting level. Next attach the Add On Rod to the Center RH (BRK) Assembly. Secure the Center RH (BRK) Assembly to the 41 LBS. SteelTop Plate, slide on the three Add On Weights and attach another Add On Rod to the Weight Cage. Attach bigger end of the Selector Pin Lanyard to the Center RH (BRK) Assembly, and the other end to the Weight Selector Pin. Then Wrench tighten bolts.

Part Descriptions		Hardware Descriptions
33	- Center RH (BRK) Assembly	K - 3/8”-16 x 1” Button Head Screw (Black Zinc)
34	- Add On Rods	L - 5/16”-18 x 1” Button Head Screw (Black Zinc)
35	- Add On Weights	M - 3/8”-16 x 1” Button Head Screw (White Zinc)
36	- Weight Selector Pin	N - 3/8”-16 x 2 3/4” Flat Head Cap Screw (White Zinc)
37	- Guide Rods	AG - 3/8” Lock Washer (White Zinc)
38	- Weight Bumpers	AH - 3/8” Flat Washer (White Zinc)
39	- Guide Rod Bushings	AJ - 3/8” Lock Washer (Black Zinc)
40	- 41 lbs. Steel Top Weight	AK - 3/8” Flat Washer (Black Zinc)
41	- 20 lbs. Intermediate Weight	AL - 5/16” Lock Washer (Black Zinc)
64	- Add On Weight Bushing	AM - 5/16 Flat Washer (Black Zinc)
		AN - 3/8” Split Washer (White Zinc)
		CK - Selector Pin Lanyard
		CM - Top Weight Roll Pin
		CN - Guide Bearing (Tall)
		CP - Guide Bearing (Short)

Page 15

HOIST

FITNESS SYSTEMS

R

2403 Assembly