Hoist Fitness CL-2403 owner manual Part Descriptions

Page 26

A SS E M B LY

I N S T R U C T I O N S

Step 2k

F R A M E A S S E M B L Y

In this step start by sliding one Aluminum Ring on both the right and left handles. Then slide on one Rubber Grip on each side. Place an Aluminum End Cap on the end of the handle. Once all three pieces (per side) are in place, secure the End Caps, slide the Rubber Grip flush with the End Cap, and slide the Aluminum Rings flush with the Rubber Grips and secure. Same process for the back handle of the Seated Frame Assembly. Next use a spray can of 3M Contact 80 Neoprene Adhesive by spraying an “X” pattern and also around the edges. Now attach the Rubber Foot Pad to the Foot Rest Assembly as shown. Wrench tighten screws.

Part Descriptions		Hardware Descriptions
23	- Aluminum Ring	T - 10-32 x 1/8” Set Screw
23	- Aluminum Ring
51	- Aluminum End Cap
52	- Rubber Foot Pad
58	- Rubber Grip (10.50 LG.)
63	- Rubber Grip (8.25 LG.)

Page 25

HOIST

FITNESS SYSTEMS

R

2403 Assembly

Image 26

Contents Hoist R Contents Hoist R SS E M B LY Hoist Part Descriptions Hardware Descriptions AA a AB Weight Cage S T R U C T I O N S Factory Installation Instruction only Rubber Grip 36 LG CBG 8-16 x 1 1/2 Button Head Screw White Zinc JAH Large Cam Assembly Assembly 8-16 x 2 3/4 Flat Head Cap Screw White Zinc For Assembly Instruction See For Assembly see A-1 Cam Belt 110 LG For Assembly see B-1 For Assembly see B-2 X 4 End Cap HH AE D Including all previously hand tightened bolts Grind to Flush Head Rest Upholstery Assembly SS E M B LY Part Descriptions SS E M B LY Wrench tighten bolts ACB AB AA 41 LBS. Steel Top Plate CM Top Weight Roll Pin Stem SS E M B LY R T L I S T I N G R D W a R E L I S T I N G Owners L T S I Z I N G C H a R T S H E R S I Z I N G C H a R T I G H T R a T I O S Owners I G H T T R a I N I N G T I P S Owners Hoist R Owners N E R S C a L R E F E R E N C E Hoist Hoist R Hoist Hoist Fitness Systems General Maintenance Information Owners Hoist Fitness Systems CL2403 Contents TWO People are Required to Safely Perform this JOB Hoist Part/Hardware Descriptions Step Removing the old foot rest assembly Hoist R Swapping the handgrip assembly NEW Foot Rest Assembly OLD Foot Rest Assembly S T R U C T I O N S W E X E R C I S E a R M a S S E M B L Y Installing the new foot rest assembly Step LEG Press is NOW Ready for USE 121 R T S / H a R W a R E L I S T I N G