IBM s37l-2095-00 manual TrackPoint Checkout, Cradle Checkout, External Monitor Self-Test

TrackPoint Checkout

The TrackPoint adjusts the pointer sensor automatically. During this process, the pointer moves on the screen automatically for a short time. This self-acting pointer movement can occur when a slight, steady pressure is applied to the TrackPoint pointer. You must readjust it if the temperature has exceeded its normal temperature range. This symptom does not indicate a hardware problem. No service actions are necessary if the pointer movement stops in a short period of time.

If a click button problem or a pointing stick problem occurs, do the following:

1.Go to the diagnostic menu (see “Running the Diagnostics Test” on page 27).

2.Select TrackPoint and run the diagnostics tests.

3.Verify that the item is selected.

4.Move to another item with the pointing stick.

5.Press the pointing stick (press-to-select) and verify that the item is selected.

6.Verify that both buttons work correctly.

If the click buttons do not work, replace the mainboard. If the pointing stick does not work, do the following actions one at a time to correct the problem. Do not replace a nondefective FRU.

∙Reseat the TrackPoint cable.

∙Replace the keyboard.

∙Replace the mainboard.

Cradle Checkout

Use the following procedure to isolate a problem with the cradle. The cradle attaches to the system expansion connector at the bottom of the WorkPad z50.

1.Enter suspend mode.

2.Remove the failing device from the cradle.

3.Unplug the AC Adapter from the cradle, if attached.

4.Remove the cradle from the WorkPad z50.

5.Reconnect the failing device directly to the WorkPad z50. (If another device is already connected to the WorkPad z50, remove it first.)

6.If the failing device works properly, replace the cradle.

External Monitor Self-Test

If a monitor problem occurs, use the following instructions to correct the problem:

1.Test the external monitor and cable on another system to make sure they are working correctly.

2.Connect the monitor to the WorkPad z50.

3.Go to the diagnostic menu (see “Running the Diagnostics Test” on page 27) and select Display.

4.If the external monitor does not display correctly, change the mainboard.

WorkPad z50 Mobile Companion 15