Fisher-Price H3427 Housing, Side Fender Taillight Lens, #8 x 1 Screws, Rear, Vehicle

Page 14

F

 

ASSEMBLY

 

 

Sport Bar Support

 

Taillight

 

 

Housing

 

 

 

 

PUSH

 

 

 

HERE

 

 

Side

 

 

 

Fender

 

 

 

 

 

 

Taillight

 

 

 

Lens

 

PULL

 

 

 

HERE

#8 x 1" Screws

 

 

22

 

24

BACK VIEW

SIDE VIEW

 

 

Turn the vehicle upright.

Fit the sport bar assembly into the holes in the top side of the vehicle.

Push down firmly on a sport bar support while pulling up on the side fender to fit the sport bar into the vehicle.

Repeat this procedure on the other side of the vehicle.

 

Rear of

 

Vehicle

23

BOTTOM VIEW

Turn the vehicle on its side.

Insert two #10 x 3/4" screws into the holes (behind the rear wheels) in the underside of each rear wheel well, through the vehicle body and into the ends of the sport bar. Tighten the screws.

Next, insert two #10 x 3/4" screws into the holes (in front of the rear wheels) in the underside of each wheel well, through the vehicle and into the ends of the sport bar. Tighten the screws.

Using safety scissors, remove the taillight lenses and the taillight housings from the plastic connectors. Dispose of the plastic connectors.

Face the rear of the vehicle.

Fit a taillight lens inside a taillight housing.

Position the taillight housing with lens against the vehicle with the screw holes aligned, as shown.

Insert two #8 x 1" screws through the taillight lens, housing and into

 

the vehicle as shown. Tighten the screws.

Repeat this procedure to attach the other taillight assembly.

 

Cap

 

Tether

 

25

Position the cap so that the tether is down.

Snap the cap into the hole under the right taillight.

14

H3427a-0920

Image 14
Contents Tools needed for assembly Phillips Screwdriver For Model H3427Table of Contents Important InformationElectrical Hazard Dash CpartsVehicle Sport Bar Sport Bar Support SeatPartsc Volt BatteryTaillight Lens Set Taillight Housing Set Lens Guard Light CoverParts Picture Battery Charging Or callAssembly BatteryB Charger ConnectorAs shown Key AssemblySteering Hole Column End Steering Column Washer Rod HoleFassembly Large Slots Hood Latch SlotSlot Windshield Wipers Slot Front Bumper Hood TabsLoops Spacers Grille #8 x 3 ScrewsAs shown Slot SeatLights Seat Sport Bar Seat Back TabsSlot Supports Light CoversSide Fender Taillight Lens HousingTaillight #8 x 1 ScrewsDoor Shown Actual SizeGdecoration Decoration Battery Retainer Hood Latches Battery InstallationHood Battery Compartment Battery Care and Disposal CareDo not allow any child to drive the vehicle in the dark Safe Driving RulesAlways sit on the seat Always wear shoes Storage Vehicle OperationShifter PositionTrack Hour AdjustFM RADIO/SIMULATED CD Player Digital Clock USE BackFCC Statement Limited Warranty OVehicle Care Problems and Solutions Guide Problem Possible Cause SolutionThat there are no loose wires around the motors To prevent repeated automatic shutdowns Problems and Solutions Guide Before first-time use You must charge the battery Hours