EBATTERY CHARGING
BatteryB
A
Charger
Connector
•Plug the charger connector into the battery A .
•Plug the charger into a standard wall outlet B .
Note: If power flow to the wall outlet is controlled by a switch, make sure the switch is “ON”.
•Before
•Recharge the battery for at least 14 hours after each use of your vehicle. Do not charge the battery longer than 30 hours.
•Once the battery is charged, pull firmly on the charger connector to disconnect it from the battery. Unplug the charger from the wall outlet. The battery is now ready to be installed in your vehicle.
Please see the Battery Installation section on page 18 for detailed instructions on installing your battery. If your battery is already installed in your vehicle, simply
ASSEMBLY
WARNING
Children can be harmed by small parts, sharp edges and sharp points in the vehicle's unassembled state, or by electrical items. Care should be taken in unpacking and assembly of the vehicle. Children should not handle parts, including the battery, or help in assembly of the vehicle.
| B | B |
| A | |
| B |
|
A |
| Dash |
|
| Motor |
|
| Harness |
|
| Connector |
|
| Wire |
1 |
|
|
A | B |
|
•Position the dash on the vehicle.
•Make sure the motor harness connector wire is through the groove in the dash.
•Insert a #10 x 1/2" screw through each of the two corner dash tabs nearest to the passenger compartment A .
•Insert a #10 x 1" screw through the two dash tabs nearest to the battery compartment B .
• Insert a #10 x 1" screw into the hole in the center of the dash B .
• Tighten the screws.
8 |