F
Assembly
1 | Dash | 1 | 2 |
| |||
|
| ||
2 |
|
| |
1 |
|
|
|
Tab |
|
|
|
|
|
| Channel |
|
|
| Cover |
1 |
| 2 |
|
•Position the dash on the vehicle body. Make sure the holes in the dash tabs align with the holes in the vehicle body and that the channel cover is captured by the dash.
•Insert two #10 x 1" screws through the holes towards the rear of the dash (closest to the hood area) and into the vehicle body 1 .
•Insert two #10 x 1/2" screws through the holes towards the front of the dash (closest to the passenger compartment) and into the vehicle body 2 .
•Tighten each screw with a Phillips screwdriver. Do not
2
Knobs
Knob Plate
•Snap the knobs into the knob plate.
Note: Gently squeeze the tabs on the knobs together before inserting the knobs into the knob plate.
3 | Dash | Knob Plate |
|
|
| ||
| Key Assembly |
|
|
|
| Microphone | |
|
| Cord |
|
• Bend the end of the microphone cord so that it forms a “T”.
•Insert the end of the microphone cord through the square opening in the dash pocket. Pull gently on the cord to make sure it is secure in the dash.
•Hook the microphone onto the “U” slot on the dash pocket.
•Position the bottom edge of the knob plate in the opening in the dash.
•Snap the top of the knob plate into the dash.
•Snap the key assembly into the dash.
4 |
| 9 |
|
|
| 25 |
|
|
| HILOP | 24 |
11 | 17 | 12 | PAUSE COMP RDM REV FWD |
15
3
18 |
Dash View
•Before applying labels to the dash, wipe the dash with a clean, dry cloth to make sure it is free of dirt and oils. Make sure your hands are clean and dry.
•Apply labels as shown. For best results, avoid repositioning a label once it has been applied.
10