|
| Assembly |
|
24 | Sport Bar | 26 | Taillight |
|
|
| Housing |
| PUSH |
|
|
| HERE |
|
|
Side |
|
|
|
Fender |
|
|
|
|
|
| Taillight |
|
|
| Lens |
PULL HERE |
|
|
|
|
| • Using safety scissors, remove the taillight lenses and the | |
|
| taillight housings from the plastic connectors. Dispose of | |
|
| the plastic connectors. | |
• | Fit the sport bar and sport bar support legs into the holes | • Face the rear of the vehicle. | |
| in the vehicle body. | • Fit a taillight lens inside a taillight housing. | |
• | Push down firmly on a sport bar side leg while pulling | • Position the taillight housing with lens against the vehicle | |
| up on the side fender to fit the sport bar into the | body with the screw holes aligned, as shown. | |
| vehicle body. | • Insert two #8 x 1" screws through the taillight lens and | |
• | Repeat this procedure on the other side of the | ||
housing and into the vehicle body as shown. | |||
| vehicle body. | • Tighten the screws with a Phillips screwdriver. Do not | |
|
| ||
|
|
25 | Sport Bar |
|
•Insert a 11/2" x 1/4" machine screw into the hole closest to the front of the vehicle in the underside of the rear wheel well, through the vehicle body and into the end of the sport bar.
Important! Make sure to assemble the two 11/2" x 1/4" machine screws to hold the sport bar and the sport bar supports in place.
• | Tighten the screw with a Phillips screwdriver. Do not |
|
|
| |
• | Repeat this procedure on the other side of the | 16 |
| vehicle body. | |
|
|
• Repeat this procedure to attach the other taillight.
27 |
Gas Cap |
Tether |
•Position the gas cap so that its tether points down.
•Snap the gas cap into the hole under the right taillight.