1 & 2
Tab locks into hole
4
5
6
To Assemble Rear Wheels
1Turn stroller over as shown.
2Position rear axle assemblies as shown, with red brake levers pointing towards stroller handle.
3Push rear axle assemblies onto rear leg tubes at the same time.
4Make sure plastic tabs on rear axle lock into holes on rear legs as shown.
5Slide a wheel onto the axle than slide a washer onto the axle.
6Fit straight part of cotter pin through hole on axle as shown.
7Line up each of the tabs in the hub cap with the slots in the wheel, snap hub cap into place.
8Repeat for second side.
4