Mobility Electronics PS6S1800M manual HotSync with a Remote Location

Page 7

invision Serial/Modem Charging Cradle User Guide

HotSync with a Remote Location

To HotSync your terminal with data at a remote location, follow these simple steps:

Connect one RJ-11 end of the included telephone cord into a standard analog telephone wall jack.

Connect the other RJ- 11 end to the “Line- In” jack on the back of the PS6S1800M cradle.

If you plan to share your telephone line for voice communications, connect the RJ-11 end of the analog telephone cord that “used to be in the

wall” (before step above) into the “Line- Out” jack on the back of the cradle.

Set the Modem/Serial switch to Modem for modem operations.

Mobility Electronics, Inc	4

Image 7

Contents PS6S1800M Invision Serial/Modem Charging Cradle User Guide TrademarksContents Introduction Power Connection Setting up the PS6S1800MHotSync with the Computer HotSync with a Remote Location Modem Serial Operating the CradleCharging the SPT Terminal Battery Product/Technical Support TroubleshootingProduct Registration Invision Serial/Modem Charging Cradle User Guide Invision Serial/Modem Charging Cradle User Guide Other HotSync Problems Radio Frequency Interference Requirement Appendix a Regulatory InformationCanada Greek ΜΕ ΤΗΝ Παρουσα Mobility Electronics ∆ΗΛΩΝΕΙ ΟΤΙ modem Appendix B Warranty Part Number 190086-000 Rev a