7.0INSTALLATION
1.Locate a LATCH seating position as identified in your vehicle owner’s manual. Some LATCH seating positions may require deploying of anchors, or installation of guides.
2.Remove the Safety Seat from the base by squeezing the base release handle located under the center of the foot end of the
Safety Seat and lifting upward on the Safety Seat. (Fig. 25-1)
3.Remove the LATCH connectors from their storage position inside the base
(Fig. 44-1). Place the Base in the rear- facing position in a forward facing vehicle seat as shown in Fig. 45-1. The Child must face the rear of the vehicle and Safety Seat must be placed in a vehicle seat that faces forward.
4.Locate the LATCH anchors in the vehicle seat. (Fig. 44-2) Once located, snap the
Safety Seat LATCH connectors onto the steel rod. Listen for the click and check that both connectors are firmly attached to the anchor rods by pulling outward on the connectors. (Fig.
5.Proper installation of the Base requires that the LATCH webbing be very tight. To tighten the webbing, push down hard with your knee or hand on the Base while pulling upward on each webbing end. The webbing will automatically lock in
Fig.
Latch Anchor
Fig.
44