Baby Trend CSO190AD809 manual Securing the Safety Seat or Base in the Vehicle

7.0INSTALLATION

proper angle of recline, place a rolled towel, or car seat noodle, under the base at the foot end to achieve the correct position. (Fig. 48-1)

2.Safety Seat without Base: Check that the Safety Seat is level side to side on the vehicle seat. Check the level indicator as shown in Fig. 46-2.

•If the Seat Angle Indicator shows NO red, the seat is installed at the proper level of recline.

•If the Seat Angle Indicator shows ANY red, the Safety Seat is either too upright or too reclined. If the Safety Seat is too reclined adjust the Safety Seat as shown in Fig. 48-2 until the level indicator shows NO red. If the Safety Seat is too upright, place a tightly rolled towel, or car seat noodle, under the foot end of the Safety Seat until the level indicator shows NO red. (Fig. 48-3) Re-tighten the vehicle seat belt as instructed in section

Securing the Safety Seat or Base in the Vehicle.

Fig. 48-1

Fig. 48-2

Fig. 48-3

48