Graco PD246612A owner manual To Install Locking Clip, Repeat above steps until secure 2 1.25 cm

Page 21

8.6 To Install Locking Clip

1.Tighten the buckled belt by pushing down hard on the child restraint and pulling hard on the shoulder belt.

2.While pushing down on seat pinch the two straps together behind the buckle tongue. Unbuckle the belt without allowing it to slip.

3.Attach locking clip to lap and shoulder belts as shown ™.

4.Rebuckle belt. Check that lap belt does not move by pulling hard. If belt loosens or lengthens repeat procedure.

Remove locking clip when not using child restraint. Store under it’s tab on the rear of seat.

Test installation to see if child restraint is secure.

If not secure additional belt tightening may be required:

‡Unbuckle vehicle seat belt.

‡Hold belts together and remove locking clip.

‡Shorten length of lap belt portion slightly by pulling belt through latch plate. Re-attach locking clip.

‡Buckle vehicle seat belt. Press child restraint further down into vehicle seat cushion to help buckle vehicle seat belt. Test installation to see if child restraint is secure. If not secure

repeat above steps until secure.

21

 

™

12” (1.25 cm)

Image 21
Contents Featuring Table of Contents Table of Contents Page Page Register Your Child Restraint Model Number Date of manufacture Purchase DateUseful Information CertiÀcation Features Page Assembling the Head Support Assembly is now complete ‡ Never Leave Your Child Unattended Page Height and Weight Limitations With Built-In HarnessYour child must meet all requirements Without Built-in Harness Your child must meet all requirements ‡ Weight 30 to 100 lbsWithout Back Support Choosing an Appropriate Vehicle Seat Location Safe Vehicle Seat Belt Systems Vehicle Seat Belt Requirements‡ Lap Belts with Automatic Locking Retractor ALR For Built-in Harness Only‡ Combination LapShoulder Belt with Locking Latch Plate With or Without Built-in HarnessRepeat above steps until secure 2 1.25 cm To Install Locking Clip‡ Lap Belts with Emergency Locking Retractor ELR Unsafe Vehicle Belt Systems‡ Combination LapShoulder Belt with Retractor ‡ Passive Restraint Lap or Shoulder Belt Mounted on Door‡ Lap Belts Forward of Seat Crease ‡ Passive Restraint Lap Belt with Motorized Shoulder BeltLatch What is LATCH?Page Latch System Using Child Restraint with Built-in Harness Page To adMust harness straps Page Must go over red rollers Page Securing the Child Restraint in Your Vehicle Lower anchors must be stored when using vehicle beltSafety Check for Secure Installation Tighten vehicle seat beltLocation p Lay flat and not be twisted With LatchSafety Check for Secure Installation ‡ Avoid bulky clothing Securing Your Child in the Child RestraintPage Remove harness straps Harness Removal or Re-attaching HarnessPage Page Harness Strap Arm T-slot Reverse Instructions to Reinstall Harness Using Your Child Restraint Without Built-in Harness Incorrectincorrect Incorrect Incorrect Securing Child & Booster Seat in Vehicle Support setting See page 48, Adjusting Head SupportAdjusting Head Support Removing or Re-attaching Back Support Page To Reattach Back Support if Needed Page Page Rear View of Child Sitting in Seat Correct Using the Tether Storing Lower Anchors and Tether Latch Important points to remember Airplane UseTo prevent ejection in sudden stop or crash Recline Foot Care and Maintenance Prevent serious inMury or death Buckle Cleaning ProcessTo Remove or Re-attach Seat Cover Replacement Parts and Warranty