Graco PD246612A owner manual Using Child Restraint with Built-in Harness

Page 27

10.0 Using Child Restraint WITH Built-in Harness

FAILURE TO PROPERLY ADJUST THE HARNESS STRAPS

FOR YOUR CHILD INCREASES THE RISK OF SERIOUS

INJURY OR DEATH IN THE EVENT OF A SHARP TURN, SUDDEN STOP OR CRASH. Snugly adjust the belts provided with this child restraint around your child. A snug strap should not allow any slack. It lies in a relatively straight line without sagging. It does not press on the child’s flesh or push the child’s body into an unnatural position.

1.Loosen the harness straps by lifting the harness adjuster lever at front of seat near the adjustment strap and pulling the straps toward you .

2. Open harness clip .

27

Image 27

Contents Featuring Table of Contents Table of Contents Page Page Register Your Child Restraint Model Number Date of manufacture Purchase DateUseful Information CertiÀcation Features Page Assembling the Head Support Assembly is now complete ‡ Never Leave Your Child Unattended Page Height and Weight Limitations With Built-In HarnessYour child must meet all requirements Without Built-in Harness Your child must meet all requirements ‡ Weight 30 to 100 lbsWithout Back Support Choosing an Appropriate Vehicle Seat Location Safe Vehicle Seat Belt Systems Vehicle Seat Belt Requirements‡ Lap Belts with Automatic Locking Retractor ALR For Built-in Harness Only‡ Combination LapShoulder Belt with Locking Latch Plate With or Without Built-in HarnessRepeat above steps until secure 2 1.25 cm To Install Locking Clip‡ Passive Restraint Lap or Shoulder Belt Mounted on Door Unsafe Vehicle Belt Systems‡ Lap Belts with Emergency Locking Retractor ELR ‡ Combination LapShoulder Belt with Retractor‡ Lap Belts Forward of Seat Crease ‡ Passive Restraint Lap Belt with Motorized Shoulder BeltLatch What is LATCH?Page Latch System Using Child Restraint with Built-in Harness Page To adMust harness straps Page Must go over red rollers Page Securing the Child Restraint in Your Vehicle Lower anchors must be stored when using vehicle beltSafety Check for Secure Installation Tighten vehicle seat beltLocation p Lay flat and not be twisted With LatchSafety Check for Secure Installation ‡ Avoid bulky clothing Securing Your Child in the Child RestraintPage Remove harness straps Harness Removal or Re-attaching HarnessPage Page Harness Strap Arm T-slot Reverse Instructions to Reinstall Harness Using Your Child Restraint Without Built-in Harness Incorrectincorrect Incorrect Incorrect Securing Child & Booster Seat in Vehicle Support setting See page 48, Adjusting Head SupportAdjusting Head Support Removing or Re-attaching Back Support Page To Reattach Back Support if Needed Page Page Rear View of Child Sitting in Seat Correct Using the Tether Storing Lower Anchors and Tether Latch Important points to remember Airplane UseTo prevent ejection in sudden stop or crash Recline Foot Care and Maintenance Prevent serious inMury or death Buckle Cleaning ProcessTo Remove or Re-attach Seat Cover Replacement Parts and Warranty