• Combination Lap/Shoulder
Belt with Sliding Latch Plate |
| |
This belt has a latchplate that |
| |
slides freely along the belt. |
| |
This belt MUST be converted to prevent |
| |
movement of the lap portion of the belt. You |
| |
must use the locking clip provided with the |
| |
infant restraint, unless your vehicle's seat belt | Locking clip | |
can be converted in another way as described in |
| |
your vehicle owner's manual. |
| |
To Install Locking Clip: | ½ | |
1. Tighten the buckled belt by pushing down | ||
inch | ||
hard on the infant restraint and pulling | ➊ | |
hard on the shoulder belt. | ||
2. While pushing down on infant restraint, |
| |
pinch the two straps together behind the |
| |
buckle tongue. Unbuckle the belt |
| |
without allowing it to slip. |
|
3.Connect lap and shoulder belts with locking clip as shown ➊ and ➋.
4.Rebuckle belt. Check that lap belt does not move by pulling and pushing hard on infant restraint. If belt loosens or lengthens, repeat procedure.
➋
Locking clip goes here, 1/2 inch from the buckle
24