Graco 1000 STETM instruction manual Locking Clip

Page 21

VEHICLE SEAT BELTS (continued)

Locking Clip

WARNING

Avoid serious injury or death:

Failure to use locking clip where required will result in car seat not being securely held in place.

Remove locking clip from seat belts when not being used with car seat.

DO NOT use locking clip as a vehicle seat belt shortener.

You MUST use locking clip provided with car seat with a vehicle seat belt that slides freely through the latch plate or the lap belt cannot be tightly secured.

1Install car seat and tighten vehicle seat belt.

2Hold seat belts together at latch plate (fig. a) then unbuckle.

3Slide locking clip on seat belts approximately 1/2 inch (1 cm) away from latch plate.

4Re-buckle seat belt.

5Test installation to see if car seat is secure.

If not secure, additional belt tightening may be required:

Unbuckle vehicle seat belt.

Hold belts together and remove locking clip.

Shorten length of lap belt portion slightly by pulling belt through latch plate.

Re-attach locking clip.

Buckle vehicle seat belt.

HINT: Press car seat further down into vehicle seat cushion to help buckle vehicle seat belt.

Test installation to see if car seat is secure. If not secure, repeat above step until secure.

1/2 inch (1 cm)

(fig. a)

19

Image 21
Contents Avoid injury or death Read and understand this manual Table of Contents Registration Information Important InformationPage Page Basic Information Height & Weight Limits Preterm or Low Birth Weight InfantsOutgrowing Car Seat REAR-FACING Installation Fig. d FORWARD-FACING InstallationOverhead Shield Models Only Placing Child in CAR SeatPlacing Child in CAR Seat Operations and Adjustments Point Shield Models Overhead Shield Adjustment fig. e ModelsAll Vehicle Seat Belts Belts Forward of Seat Crease Vehicle Seat BeltsLap Belts With Retractor Lap Belts Manually AdjustablePassive Restraint Lap or Shoulder Belt Mounted on Door Passive Restraint Lap Belt with Motorized Shoulder BeltCombination Lap/Shoulder Belt with Locking Latch Plate Combination Lap/Shoulder Belt with Sliding Latch PlateLocking Clip Installation of Anchor Hardware Additional InformationAnchor Hardware Additional Information Tether Storage Removing Overhead Shield Pad Care & CleaningSeat Pad and Overhead Shield Pad Second Hand Car Seat Aircraft UseCall US First Manual de instrucciones Índice Uso del asiento para el automóvilAntes de comenzar F Información especial Información para registro Información ImportanteAdvertencias Evite las lesiones graves o la muerte Page Certificación Información BásicaAsiento para el automóvil desocupado Duración de funcionamiento del asiento para el automóvilLímites DE Estatura Y Peso Bebés prematuros o que pesen menos de lo normal al nacerCuando el asiento le queda pequeño Instalación Orientado Hacia Atrás Fig. d Instalación Orientado Hacia DelanteSolamente para los modelos con 5 puntos Colocación DEL Niño EN EL Asiento Para EL AutomóvilModelos Protector Puntos Correas del arnés fig. a Operaciones Y AjustesOperaciones Y Ajustes continuación Nota Los Cinturones DE Seguridad DE LOS Vehículos Cinturones por delante del pliegue del asiento Cinturones DE Seguridad DE LOS Vehículos continuaciónCinturones de regazo Con retractor Cinturones de regazo Ajustables manualmenteNo lo use con ningún asiento para el automóvil Fig. a Voltee Abrazadera de inmovilización Almacenamiento de la correa de sujeción Información AdicionalCuidado y limpieza Información Adicional continuaciónAlmohadilla del asiento y almohadilla del protector elevable Asiento para el automóvil de segunda mano Uso en los avionesLlámenos Primero