Screw hinge spindles (c) into top and bottom rails of gate section (h) until they are exten- ded equally. These will be adjusted to the correct length at a later stage so do not tighten.
Repeat process on gate section (i) using latch spindles (m).
Mounting Locking Side
Screws provided are for mounting directly into wood. If mounting into brick, drywall or other surfaces, use appropriate hard- ware. If installing into hardwood (i.e. oak), drilling a pilot hole may be necessary.
Hold template (j) against mounting surface in line with opposite hinges, making sure end marked “1” is even with floor.
Mark 4 screw hole positions.
Remove template .
Determine which direction the gate should open. For stairways, gate should never open out over stairs.
Using 2 screws (q), screw bottom locking bracket (p) into lower set of screw holes with opening side facing direction gate will open.
Fit locking latch (k) into locking latch bracket
(l).
5