MODEL
MOUNTING INSTRUCTIONS
INSTALLATION ON CONCRETE CURB
1.Uncrate the gate. Avoid damaging the cabinet finish.
2.Leave the machine bolted to the bottom pallet until ready to install.
3.Open the cabinet door.
4.Remove the bolts holding the gate to its pallet and place the machine in position on the curb. Refer to your Equipment Layout (EL) drawing for proper positioning of your gate.
5.With a pencil, mark the location of the mounting holes on the concrete.
6.Set the gate aside. Drill all four mounting holes using a 3/4” diameter rotary hammer percussion drill bit. Insert lag screw anchors for 1/2” lag bolts. Place the gate back in position, and anchor it with 1/2” lag bolts and flat washers. Lubricate the bolts before installation. Flat washers have been supplied to go between pavement and cabinet. LINEAR highly recommends using the corner mounting holes when mounting barrier gates.
7.Proceed with the rest of the installation process.