Graco 309572ZAF important safety instructions 15F144 Hose Wire Jumper, Fluid Temperature

Parts

15F144 Hose Wire Jumper

Use the 15F144 Hose Wire Jumper to heat only the major volume hose, in a wide ratio system.

To build one complete 50 ft single side heated hose bundle, order the following parts:

Ref.	Part	Description	Qty
100	15F144	JUMPER, hose wire	1
101		HOSE, resin, heated; 50 ft	1
		(15.2 m) minimum; see tables
		starting on page 4
102	24J523	CABLE, FTS	1
104	261670	FLUID TEMPERATURE	1
		SENSOR; see page 25
105	pur-	HOSE, hardener, unheated; 50	1
	chase	ft (15.2 m) minimum; customer
	locally	supplied
106	pur-	CONNECTORS, fluid; as	as
	chase	required to complete assem-	req’d
	locally	bly; not shown

Install as follows:

This hose must be used with an FTS and cable to provide grounding.

1.Wrap hose wire jumper (100) around resin hose (101) in a spiral fashion.

2.Connect resin hose wire (101a) to other side of Power-Lock connector (100a); see page 13.

3.Wrap FTS cable (102) around resin hose

(101)in a spiral fashion.

4.Twist hoses (101 and 105) together to pro- vide strain relief.

5.Repeat steps 1-4for each length of hose

(101).Connect hoses, electrical connec- tors, and cables; see Connect Heated Hoses, page 13.

6.Install one -Lock connector (100a) between wires; see page 13.

7.Connect FTS with a Non-Heated Whip Hose or Remote Mix Manifold, page 20.

30 309572ZAF