Clover Electronics Z670 instruction manual Installation

-Click the “PAN/TILT & REMOTE” button in the PAN/TILT menu shown in Fig.4-5, then the vendor lists will show up. Select “PELCO” on the vendor lists by clicking the mouse and then the protocol “PELCO D” will display.

-Click the “BAUD RATE” button in the PAN/TILT menu and choose 2400bps among 1200bps, 2400bps, 4800bps, 9600bps, 19200bps, 38400bps, 57600bps and 115200bps on the Baud Rate pop-up window by clicking the mouse.

-Do not change the settings for Data Bits, Stop Bits and Parity Bits.

Tips for Quick Setup on the DVR system:

-Enter the same ID as the zoom camera has.

e.g.1: if the ID of the zoom camera is “000”, enter “0” in the PTZ ID box.

e.g.2: if the ID of the zoom camera is “007”, enter “7” in the PTZ ID box.

-The protocol should be “PELCO D”.

-Choose the Baud Rate (communication speed) 2400bps on the pop-up menu.

5.INSTALLATION

▪Connect the RED and BLUE colored wire of the Data Cable (Twisted Pair Cable) to the “+” and “-“ terminals on the rear of the camera and the DVR system as shown in Fig5- 1. Refer to the instruction manual of DVR system relevant to the location of “+” and “-“ terminals for RS485.

[Fig.5-1 Installation]

▪To connect the bared copper wire on the end of the RED and BLUE colored wire, push the terminal with “-“driver (2mm) until inserting it into the round hole as shown in Fig.5-2.