Concord Camera 3.1 Megapixels Digital Camera manual Symptom Possible Cause Possible Solution

		TROUBLESHOOTING
SYMPTOM	POSSIBLE CAUSE	POSSIBLE SOLUTION	En
The images are dark on the	Configuration and settings of	The display setting of the
computer and when printing, but	computer and printer need to be	computer can be adjusted via the
all images look fine in Review	adjusted.	Control Panel’s Display section
Mode.		or the actual display settings of
		the monitor.
		The printer’s setting can be
		adjusted via the Control Panel’s
		Printers.
		Refer to the user’s documentation
		that comes with the computer
		and printer.
TAKING PICTURES
Flash picture taken is too light.	Subject is too close.	Move the subject further away
		from the camera.
	The flash is not needed.	Change the camera setting to
		Auto Flash. See p. 12.
	Lighting condition is too bright.	Decrease exposure
		compensation. See p.22.
Flash Picture taken is too dark.	The subject is too far away for the	Move the subject closer to the
	flash to be effective.	camera, or move the camera
		closer to the subject.
	Flash is not on.	Select “Auto Flash” or “Flash On”
		setting.
	The subject is in front of a bright	Change the subject’s position
	light.	if possible or move to another
		location to take the picture of the
		subject from another angle.
	Lighting condition is too dark.	Increase the exposure
		compensation. See p. 22.
Flash did not work.	There was sufficient lighting for	This is normal, as your camera’s
	the picture, so the flash did not	electronic light sensor is
	fire. This happens when the	programmed to only fire the flash
	camera is set to Auto Flash.	when needed.
	Camera’s flash has been turned	Select “Auto Flash” or “Flash On”
	off.	setting.
	Flash did not charge.	Ensure that the Ready LED has
		stopped blinking before taking a
		picture.
	Selected the Continuous or Sport	When the Continuous or Sport
	mode.	mode is selected, the flash is
		disabled.
My fresh set of batteries took	Depends on the level of usage.	To save power, turn off the LCD.
only a few pictures and they are	Auto-Focusing, zooming in and	When the camera is not in used,
now flat.	out are some of the functions that	power it off. Economize on
	tend to draw more power.	the use of the Auto-Focus and
		zooming functions

62