Pelco c2462m-e manual Focus Adjustment, To adjust the focus Loosen the focus locking screw

Page 16

FOCUS ADJUSTMENT

NOTE: You will need a miniature Phillips or flat-tip screwdriver to loosen and tighten the locking screw.

To adjust the focus:

1.Loosen the focus locking screw.

2.Position the inverted dome approximately 0.125 inch (3.175 mm) from the front of the lens. Make sure that the lens and the dome are centered (refer to Figure 11).

3.Turn the focus locking screw clockwise or counterclockwise to adjust the focus.

4.When the optimal focus is reached, tighten the focus locking screw.

FOCUS 0.125 INCH (3.175 mm)

CENTER BUBBLE

WITH LENS

Figure 11. Adjusting the Focus

16

C2462M-E (3/09)

Image 16
Contents Camera System Contents List of Illustrations Important Safety Instructions Regulatory NoticesParts List DescriptionRemove the Dome Bubble Removing the Dome BubbleInstallation Surface Installation CEILING/WALLCeiling/Wall Installation IN-CEILING Installation Suspended Ceiling Standoff Back BOX Surface Mount Ring IN-CEILING Installation Fixed Ceiling or Wall Pinch the sidesSurface Installation 4S Standard Electrical BOX Standard Electrical Box InstallationIN-CEILING Installation 4S Deep Electrical BOX Deep Electrical Box InstallationCamera Positioning Camera Adjustments Switch SettingsFocus Adjustment To adjust the focus Loosen the focus locking screwVertical Phase Adjustment Install Liner and Bubble Dome Liner InstallationDome Bubble Installation Installing the Dome BubbleService Connector Attaching the 2.5 mm Monaural Headphone PlugSpecifications ElectricalRevision History Product Warranty and Return Information