Installation
The installation methods for the ICS090 Series include the following options:
•Mount to the surface of a ceiling or wall
•Install in a suspended ceiling
•Install in a fixed ceiling or wall
•Mount to the surface of a 4S standard electrical box
•Install in a 4S deep electrical box
SURFACE INSTALLATION: CEILING/WALL
Refer to Figure 2 on page 8 for the following steps. Refer to Figure 3 on page 8 if you are installing the unit to the surface of a concrete ceiling or wall.
1.Pull the video and power wires through the ceiling/wall.
2.Connect the video cable and wires.
BNC: Connect the BNC connector from the Camclosure to a mating BNC connector.
Twisted pair: Connect the blue wire to Video +; connect the gray wire to Video
3.Connect the power wires (refer to Table A).
Table A. Power Input: Surface, Ceiling/Wall Installation
Voltage | Red Wire | Black Wire |
|
|
|
12 VDC | + | Ground |
|
|
|
24 VAC | – | – |
|
|
|
AC operation only: If you are wiring more than one Camclosure to the same transformer, connect one side of the transformer to the red wire on all units; connect the other side of the transformer to the black wire on all units.
NOTE: Failure to connect all of the units in the same way will cause the cameras to be out of phase with each other, which might produce a vertical roll when switching between cameras.
7 |